15
WARRANTY
CENTER
C
E
R
T
I
F
I
E
D
FUNCTION 3: Up Sensitivity Adjustment
Controls the operation of the AUTO UP feature. If the unit continues to run once retracted, INCREASE the
sensitivity. If the unit stops running prematurely, DECREASE the sensitivity.
NOTE: Default settings are in the middle of the range. Tone increases with level (1-10).
1. Press and hold the PROGRAM button for six seconds until LED flashes RED and two chimes are heard
followed by 3 BEEPS.
2. Press the UP button to increase sensitivity and the DOWN button to decrease sensitivity.
3. Once you have made all desired setting changes, press and release the PROGRAM button to save
your settings and exit program mode. You will hear a series of beeps and the LED will return to flashing
GREEN.
FUNCTION 4: Down Sensitivity Adjustment
Controls the operation of the AUTO DOWN feature. If the unit turns off prematurely during deployment,
DECREASE the sensitivity. If the unit continues to run once anchored, INCREASE the sensitivity.
NOTE: Default settings are in the middle of the range. Tone increases with level (1-10).
1. Press and hold the PROGRAM button for six seconds until LED flashes RED and two chimes are heard
followed by 4 BEEPS.
2. Press the UP button to increase sensitivity and the DOWN button to decrease sensitivity.
3. Once you have made all desired setting changes, press and release the PROGRAM button to save your
settings and exit the program mode. You will hear a series of beeps and the LED will return to flashing
GREEN.
C-Monster Top Side Controls (continued)
SECTION 1.9 – Electronics & Controllers
To Next Page
Loading...
Need help?
General