Assembly Of Shoulder Strap
WARNING: Proper shoulder strap and handlebar adjustments must be made with the
engine completely stopped before using unit.
1. Assemble and adjust the shoulder harness and belt.
2. Adjust the shoulder-harness button,and move the hook to your waist, then adjust the belt (If there
is a belt).
3. Hang the latch tab on the harness hook.
4. If the brush cutter doesn't balance,then adjust the harness hanger,and the handlebar,until the it
balances.
5. To quickly detach the brush cutter from the harness, pull the quick-release latch tab upward.
6. Insert the latch tongue in the slot of the quick-release latch to reattach the brush cutter to the
harness.
NOTE:Before using, please check the shoulder harness and confirm it is OK. Encounter
danger,please stop the brush cutter immediately,and pull the quick-release latch tab,the brush cutter
will be depart from your body.
Add Oil
This product is shipped without oil. User must add the proper amount of oil before operating
the product for the first time. The oil capacity of the engine crankcase is 2.8 fl. oz. For general use
(above 40° F), we recommend 30W, 4-stroke engine oil.
Engine oil recommendations
Select good quality detergent oil bearing the American Petroleum Institute (API) service
classifications SJ, SL, or SM (synthetic oils may be used). Use the ASE viscosity grade of oil from the
following chart that matches the starting temperature anticipated before the next oil changes.
To add oil, follow these steps:
1. Make sure the product is on a level surface. Tilting the product to assist in filling will cause oil to
flow into engine areas and will cause damage.
2. Unscrew the dipstick from the engine.
3. Slowly add the engine oil.
4. To check the oil level, wipe the dipstick with a clean rag.
Engine Oil Temperature Recommendations