- 21 -
2. IOS WIFI Module Set Up Steps：
Open “Appstore” ,search “pool system”,the first App appeared is the correct
one ,download and operate based on below steps.
(There is a difference compare the Android version of the connection from step4.)
Step 1：
Turn it on，when the drive by wire controller is out of full screen，buzzer rings
a sound like “Di”, it shows to be in the AP mode. Only when being in the AP mode,
the heat pump can be equipped with the WIFI module；
Enter the AP mode by hand（Press the button of
+ +
for 3 seconds in the
same time. When entering the AP mode, the button is twinkling；
Step 2：
Turn on the WIFI on phone and get it connected to the WIFI hot spot，the WIFI hot
spot should be connected to the internet，show on the picture：Connected to WIFI
hot spot“TP-LINK_1906”；
To Next Page
Loading...
