PAGE 16 OF 19
Finishing touches
1. Using the 40mm galvanised nails, fit the bargeboards to the high side and ends of the roof. Again,
these may need cutting down with a saw depending on what size building you have. There is no
bargeboard for the low side as it could trap rainwater from running off the roof.
1. Secure corner strips at each corner of your Power shed with 40mm nails (at least four per strip).
Extra strips are provided to cover the joins between side wall panels.
2. Secure the door pull to the door with 25mm screws.
3. Peel the protective blue sticker off the Power branding plate above the door.
To Next Page
Loading...
