18
Using a funnel and keeping the bottle level, pour the petrol firstly
in the left hand side up to the required level (B), and pour oil to the
level marked (A). Shake vigorously to mix the petrol and oil prior to
pouring into the tank (C).
A
B
NOTE: There are two faces of this bottle: one is 40:1 and the
other is 25:1, please always use 40:1 for reference.
C
D
Clean the surface around the fuel cap to prevent contamination.
Loosen the fuel cap slowly. Rest the cap on a clean surface.
Carefully pour fuel into the tank. Avoid spillage. Prior to tightening
the fuel cap, clean and inspect the seal located inside the fuel cap.
Immediately replace the fuel cap and hand tighten. Wipe up any
fuel spillage.
FILLING THE LUBRICATION OIL
NOTE: It is normal for smoke to be emitted from a new engine
after first use.
Whenever you refill the fuel tank with petrol, you must also top up
the level of chain oil in the chain oil reservoir.
Use special chainsaw oil to lubricate the saw chain.
NOTE: Most stores will sell acceptable oil under the name
‘Chainsaw chain oil’.
To Next Page
Loading...
