29
3. Chain bar
When the chain bar is dismounted, remove sawdust from the bar
groove and the oiling port.
Grease the nose sprocket through the grease port on the tip of the
bar.
4. Spark plug
To ensure that the saws engine retains its power, the spark plug
must be clean and have the correct electrode gap (0.6mm).The
spark plug (B) must be cleaned or replaced after every 20 hours of
service.
a. Set the 0n/0ff switch to stop (0).
b. Remove the top air filter cover.
c. Disconnect the ignition cable from the spark plug by pulling
and twisting it simultaneously.
d. Remove the spark plug using the supplied spark plug wrench.
DO NOT USE ANY OTHER TOOLS.
e. Clean the spark plug with a copper wire brush and refit it or fit a
new spark plug. Then replace the top cover.
5. Others
Check for fuel leakage, loose fastenings and any damage to major
parts, especially handle joints, chain bar mounting and silencer. If
any defects are found, make sure to have them repaired before
operating the unit again.
B
To Next Page
Loading...
