Safety Features And Proper Use
1. Removing or replacing the handle and
weights from the nest must be done in a
straight motion. (Image 1)
2.Turning the handle sideways while
lifting may jam the assembly. (Image 2)
Do not use if weights are jammed.
Using while jammed may result in falling
weights and/or injury to you or others
around the weights.
DANGER
3. The weight selector pins contain magnetic
blocks. Make sure the magnetic blocks
contact the round side rails. The selector
pin should be horizontal under the desired
weight (Image 3). Be careful not to cross pin
(image 4).
Image 1
Image 2
Always check the selector pin to make sure it is
fully inserted right side up and completely
engaged before lifting the dumbbell to avoid
injury. See image 3 If the selector pin
disengages from the from the side rails, stop
use immediately. Place PowerBlock on nearest
at surface and fully engage selector pin
magnetic blocks securely to the side rails.
Failure to maintain full and correct contact
between magnetic blocks in selector pin and
side rails may result in weights falling and/or
injury. Do not use the PowerBlock without the
tether cord being in good working condition
and attached to the top side rail and selector
pin. Weight selector pin may fall out of
PowerBlock if used without tether cord and
may result in falling weights and/or injury.
WARNING
4. Your PowerBlock features a tether cord which
attaches the selector pin to the weight plates on
the #1 or top most weight plate side rail. The tether
cord will prevent the selector pin from being
misplaced. The tether cord also serves as a safety
retainer for the weight selector pin in the event the
magnetic blocks ever lose contact with the side rails.
Image 3
Image 4
WORLD’S BEST DUMBBELL
3
To Next Page
Loading...
