Care And Maintenance
1. Do Not bang PowerBlock® dumbbells together and/or against other
pieces of equipment.
2. Do not drop the PowerBlock®. Dropping the weight plates from a height
of more than 12 inches will void the warranty.
Dropping an un-nested weight plate from any height could result in
permanent deflection of the unit and will void the warranty.
3. Should any weld break, stop using the PowerBlock® immediately and
refer to the warranty instructions.
4. Inspect equipment before each use for loose or worn parts (including
bolts). Replace worn parts at first sign of wear. Failure to replace worn
parts may result in injury. Tighten loose bolts.
5. You may apply “Armor All” to painted weight plate assemblies (do not
apply over bands on side rails). This will remove cosmetic scratches and
serve as a lubricant for nested assemblies.
6. If Paint chipping does occur as a result of normal use, liquid paint can
be used for touch-up. As a result of shipping or extended use, the nesting
of the weight plates may cause some scuffing of the powder painted finish.
Use of an “Armor All” type product will help restore this condition and
provide best performance.
Banging PowerBlock® dumbbells could dislodge pins
and result in falling weights and/or injury.
WARNING
Use of PowerBlock® with any cracked or broken weld could
result in falling weights and/or injury. Failure to replace
warn parts may result in injury. Tighten loose bolts.
WARNING
WORLD’S BEST DUMBBELL
5
To Next Page
Loading...
