9
- Switch both batteries on.
- Press the SET button and hold it pressed in until the following display ap-
pears:
- Press button II until the cursor (hollow circular ring) lines up with Power
Manager, then press the SET button. The following display now appears:
If you wish to change one of the settings, use buttons I and II to move the
cursor to the appropriate menu point, then press the SET button to select it
(cursor changes to a solid disc). You can now alter the value using buttons
I and II. Once you have selected the desired value, press the SET button to
confirm it; this saves (stores) the new value. Select the menu point OK to
return to the main menu.
Note: the presence of a solid disc (instead of a ring) indicates that you
are in a menu point.
It is possible to alter a value more quickly by holding one of the two buttons I
or II pressed in; the value then starts to change slowly in the corresponding
direction, and the rate of change accelerates with time.
To Next Page
Loading...
Need help?
General
