Need help?Do you have a question about the PowerBox Systems PowerBox Pioneer and is the answer not in the manual?
General| Input Voltage | 4.0V - 9.0V |
|---|---|
| Temperature Range | -30°C to +85°C |
| Operating Temperature | -30°C to +85°C |
| Supported Telemetry Systems | Futaba, Jeti, Multiplex |
| Protection Features | Overcurrent |
Details connection for PowerBox CORE, Jeti EX-BUS, and Futaba S.BUS2 systems.
Guidance on connecting batteries, emphasizing type, capacity, and polarity.
Instructions for connecting and operating button or MicroMag magnetic switches.
Importance of correct installation angle for iGyro SAT functionality.
Instructions for connecting GPS II for gyro functionality with compatible systems.
Steps for connecting adapters and using the PowerBox Terminal App for setup.
Setting the servo signal repeat rate (e.g., 12ms, 16ms, 18ms).
Selecting a channel to reset consumed battery capacity.
Function to reset all gyro configurations.
Selecting an output for pre-defined servo position on signal loss.
Steps for setting up gyro functions for a new model.
Steps for setting up gyro functions for a model already test-flown.
Encourages using the Support Forum for assistance before contacting by phone.
Details the 24-month guarantee covering material faults and replacements.
Lists conditions not covered by the guarantee, like misuse or wear.
Provides the official service address for claims and repairs.
To Next Page
