www.powerbox-systems.com 3
basic system is Plug ‘n’ Play, and no further adjustments are required to operate it.
This does not apply if an iGyro SAT is installed, or if you wish to change the frame
rate or the capacity reset channel.
Users of Core and Jeti systems have the facility to carry out all adjustments at the
transmitter. The alternative - which must be used by Futaba pilots - is to use a USB
lead or BlueCom adapter. In this case all set-up work can be carried out using the
associated App.
Connecting the receivers
- PowerBox CORE
Connect the P²BUS output of one or two receivers to RX1 and RX2. If only one recei-
ver is connected, then it must be connected to RX1 for telemetry transmission.
- Jeti EX-BUS
Set one output of the receivers you wish to use to EX-BUS. The frame rate should
be set to 10 ms, and the Failsafe function must be set to “OFF”. If only one receiver
is connected, then it must be connected to RX1 for telemetry transmission.
- Futaba S.BUS2
Connect the S.BUS2 output of one or two receivers to RX1 and RX2. If only one
receiver is connected, then it must be connected to RX1 for telemetry transmis-
sion. This receiver must also be set as the telemetry receiver at the transmitter.
In order to receive telemetry data you must enter the Telemetry Sensor menu at
the transmitter, and carry out a “Load New” process; this completely erases the
list of sensors. Now move to Slot 16 of the sensor list and select “PowerBox”. The
telemetry data are now displayed in Slot 16 and above.
To Next Page
Loading...
Need help?
General
