Powercom 1500AP - Appendix B Specification

16
APPENDIX B. SPECIFICATION
Model
1000AP
1500AP
2000AP
3000AP
Capacity
1000VA /
900W
1500VA /
1350W
2000VA /
1800W
3000VA /
2700W
INPUT
Voltage
220V, 230V, 240V (adjustable from 149.5V to 310V)
Frequency
50Hz / 60Hz ±10% auto sensing
OUTPUT
Voltage
On Battery: Pure sine wave at +/-5% nominally,
-10% after low battery warming
AVR
Output voltage boost when input voltage between -9%
to -27.5% of nominal; output voltage buck when
input voltage between +9% to +25% of nominal.
Frequency
50Hz / 60Hz ±0.5%
Waveform
Pure sine wave
Transfer time
6 to 8 millisecond including detection time (typical)
PROTECTION
Overload
UPS automatic power off if overload exceeds 110% of
nominal at 20 seconds; 125% at 5 seconds
Surge
300Joules, 2ms
Short circuit
UPS output cut off immediately or protected by
input circuit breaker
Tele-communication
RJ45 x2
EMI / RFI filter
100kHz to 10MHz
Fuse
Yes
Alarm
Buzzer beeps under backup mode, battery low,
battery charging fault, and overload
BATTERY
Type
Sealed, maintenance-free lead acid battery
Typical recharge time
3 hours to 90%
Battery quantity
9Ah x2
7Ah x4
9Ah x4
9Ah x6
GENERAL
Protection
Automatic diagnostics, over-discharge and
short circuit protection by fuse
Dimension (WxDxH)
428 x 453 x 84
mm
428 x 563 x 84 mm
428 x 669 x 84
mm
Display
LED indicator
Communication
interface
Standard - RS-232, RJ45 and USB B-type; *Optional - SNMP
Audible noise
<50dBA (1 meter from surface)
Ambient operation
0 to 40℃, 0 to 95% humidity (non-condensing)
○,
c
2014 All right Reserved. All trademarks are property of their respective owners. Specifications subject to change without notice.