21 GB/IE
5. Press the READ button to measure the height.
The measured height appears in the upper
row of the display. The results of the volume
calculation appear in the lower row.
Addition of volumes
1. Measure a volume as described in the section
„Measuring volumes“.
2. Press the M button
7
. The message „M+“
appears in the display
2
. The measured
volume is saved.
3. Press the MODE button
4
. The appliance is
now ready for the second measurement.
4. Measure the next volume.
5. Press the + / = button
12
. The message „+“
appears in the display.
6. Press the RM button
10
. The result of the first
measurement is shown in the lower row of the
display.
7. Press the + / = button again. Both measure-
ments are added and the result is shown in
the lower row of the display.
8. Repeat steps 2 to 7 to add further measure-
ments.
9. Press the MODE button to leave the addition
mode. All the measurements will be deleted.
To Next Page
Loading...
Need help?
General
