24 GB/IE
2. Slide the two stud buttons
5
11
firmly down-
wards. The nails lightly penetrate the wall to
prevent the multi-detector from falling.
Note: Exercise care with the studs. These
are sharp and can cause injury. Do not use
the stud button on stone or metal wall, but
only on walls with a soft surface.
Vertical laser line
1. Attach a thread to the eye at the measuring
point
1
.
2. Hang the multi-purpose detector to the point
on the wall where you would like to project the
vertical line. The appliance hangs vertically
downwards like a plumb bob. The laser pro-
jects a vertical line on the wall.
Troubleshooting
This appliance has delicate electronic compo-
nents. This means that if it is placed near an
object that transmits radio signals, it could
cause interference. If false readings occur,
remove such equipment from the vicinity of
the device.
Electromagnetic interference / high-frequency
emissions can lead to the appliance failing. In
cases of the appliance failing to work, remove
the batteries for a short while and then replace
them. Do this as described in the section
“Inserting / changing the batteries“.
To Next Page
Loading...
Need help?
General
