EasyManuals Logo

Powerfix Profi PDM 250 A2 User Manual

Powerfix Profi PDM 250 A2
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
POWERFIX PDM 250 A2
10 - English
Inserting/changing the battery
The multimeter is powered by a 9V battery. To insert or replace the battery, proceed as follows:
Switch off the multimeter and remove all test leads before opening the multimeter!
If the battery is exhausted, the
icon appears on the display [1]. The battery should be
replaced as soon as possible to ensure that the multimeter continues to work properly.
Remove the holster [2].
Remove the two screws on the back of the multimeter and remove the back panel.
Connect the 9V battery with the correct polarity (note + and –) to the battery clip and place
the 9V battery in the battery compartment.
Replace the back panel and screw it tight with the two screws.
Re-insert the multimeter in the holster [2].

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Powerfix Profi PDM 250 A2 and is the answer not in the manual?

Powerfix Profi PDM 250 A2 Specifications

General IconGeneral
BrandPowerfix Profi
ModelPDM 250 A2
CategoryMultimeter
LanguageEnglish

Related product manuals