10 GB/CY
Ensure the correct polarity when inserting the battery. This is indicated on the
battery cover (Fig. C).
Close the battery cover.
Your infrared thermometer is now ready for use.
Start-up
Hold the handle of the device so the index finger can operate the Measure
button
3
and the thumb buttons
10
to
12
.
Switching on and off
Press the Measure button
3
to switch on the device. The display
5
will light
up and a brief tone will sound.
Press and hold the °C / °F / SET button
11
for approx. 3 seconds to switch
off the device. Two brief tones will sound.
When the device is no longer being used, the backlight of the display swill
switch off after approx. 15 seconds. After approx. 60 seconds the device will
automatically switch off; this is indicated by two brief tones.
Selecting the temperature unit
After switching on, the last temperature unit used will initially be selected.
Briefly press the °C / °F / SET button
11
to change the temperature units
7
(°C or °F).
The official temperature unit in Europe in °C.
Measuring temperature
Allow about 30 minutes for the device to acclimate to the conditions of the envi-
ronment.
To Next Page
Loading...
Need help?
General
