第 10 页 共 16 页
Mode
Parameter
Default
Rang Comment
2：Square root（Responding speed is fast, fast start after
slow）；
3 4 90 0 ~1024
Pedal trimming position set, See 5-1.（the value is not higher
than the parameter [35]）
3 5 300 0 ~1024
Press foot lifting, See 5-1.
（the value is between[34]and[36].）
3 6 419 0 ~1024
Pedal back mid position，see 5-1.
（the value is between[35]and[37].）
3 7 510 0 ~1024
Pedal step upon running position，see 5-1.
（the value is between[36]and[38]）
3 8 578 0 ~1024
Pedal low speed running position（upper）,see5-1
（the value is between[37]and[39]）
3 9 962 0 ~1024
Pedal simulation the largest of value, see 5-1
（the value is not lower than the parameter [38]）
3 A 100 0 ~800 Pedal press foot lifting confirm time
4 0 1 0／1
Run to up needle position after Power on：
0: no action
1: action
41 1 0／1
Automatically reinforcing functions chose ：
（the machine head is not automatically reinforcing functions,
the best way is prohibit）
0：prohibit
1：allow
custom
setup
4 2 0 0／1
Back to sewing by hand when the function mode selection:
0：Juki mode. In sewing or in the end of the action
1：Brother mode. It acts only in sewing.
Pedal forward angle
S
To Next Page
Loading...