第 7 页 共 16 页
repeat, the icon
is lightened/ disappeared in LCD area. Whether it choice trimming that the
icon is lightened or disappeared.
3.1.6 One-Shot-Sewing key
Use key: select/non-select one-shot-sewing statues. The icon will light if select
one-shot-sewing in LCD areas, press will disappear.
3.1.7 Stop position key
Use key: select up/down stop position. Press key repeat, between up /down
stop position to switch. Choose need to stop position and stop press key to confirm. Stop
position had compiled.
3.1.8 Stitch compensation key
Use key: press this key to start stitch compensation. Compensation half needle or a half needle
due to the press time. If you keep press that compensation needle always until release button.
3.2 Technician Mode
Technician mode is used for sewing speed and pedal speed control such as the use of
performance adjustments.
3.2.1 How to enter the technician mode
Step 1: Under operator mode, press key and key, the LCD will display PD 0000, and then set
the password 0000 to enter technician mode.
Step 2: Use keys and keys to input the password, and then
press key. If the password is correct then enter technician mode, the LCD will display
00 0200 ,otherwise, it will return to operator mode.
Step 3: Change technician parameters by keys and keys. The parameters are
shown in table 2.
Step 4: Parameters values can be changed by keys and keys
Step 5: Under technician mode, press key, the panel will return to operator mode.
3.2.2 Technician mode parameter：
Table3-1:Technician mode parameter
Mode
Parameter
Default
Rang Comment
0 0 200 100 ~800 Minimum sewing speed
01 3500 200 ~5000
To Next Page
Loading...