20
EASY START INSTRUCTION
1) Apply at least 1 gallon of gas or until gas gauge shows over 2 gallons full.
2) Apply engine oil (10-30w) until you can see oil surface at the top. Apply oil cap, low
oil kill switch is know activated.
3) Turn on/off switch to ON position (located on control panel).
4) Turn fuel control valve to ON position.
5) Move air hindrance level (CHOKE) to the left. Tune Key to Start or pull Recoil Start
Rope (complete easy pulls) until start.
6) After start move Choke level to the right (slowly). If engine dies complete the above
procedures. If Choke is left on and engine dies your spark plug is known fouled and
will need to be cleaned.
7) Before you apply any plugs in to receptacles make sure you Circuit Breaker Switch
is in the ON position.
8) Enjoy your emergency/back-up power.
To Next Page
Loading...