What causes a NAC Output 2 short in POWERPATH Power Supply?
Check for a wiring short. Also, check for a shorted or improperly wired NAC Appliance. Note that if an appliance is wired + to – and – to +, a short trouble will be indicated.
What causes a NAC Output 1 short in POWERPATH PS-8?
Check for a wiring short. Also, check for a shorted or improperly wired NAC Appliance. Note that if an appliance is wired + to – and – to +, a short trouble will be indicated.
Why is there a SYNC BUS current limit on my POWERPATH PS-8 Power Supply?
There is excessive current on the SYNC BUS. Reduce the number of Power Supplies connected to the circuit.
What to do if I have processor trouble with POWERPATH Power Supply?
Disconnect DC and AC voltages from the power supply PC board. Wait 10 seconds, then reconnect. If the problem persists, replace the PC board.
What to do if I have battery charger trouble with POWERPATH Power Supply?
Remove the batteries from the terminals. Using a DC voltmeter, check the voltage across the terminals. The voltage should be 26.5VDC or higher. If the voltage is not present, the battery charger section has failed. Replace the PC Board. If the voltage is present, replace the batteries.
How to locate a ground fault in POWERPATH PS-8 Power Supply?
Shut off AC Mains Power to the unit. Open the cabinet door. Press and hold SW5, the Ground Fault Locator Switch, for 5 seconds, then release it.
What should I do if I encounter a system trouble with my POWERPATH PS-8 Power Supply?
Check the Coded Trouble LED Indicators and the Ground Fault LED. Repair any problems indicated. If no indication is observed, replace the Control PC Board.
What to do if I'm having battery trouble with my POWERPATH PS-8?
Check the battery wiring and terminal connections. If needed, replace the batteries. Alternatively, remove the batteries and check the voltage across the terminals with a DC voltmeter. It should be 26.5VDC or higher. If not, the battery charger section has failed, so replace the PC Board. If the voltage is present, replace the batteries.
Introduces the PS-8 and PS-6 models, their differences, and general capabilities of the POWERPATH NAC Extender.
Details approvals, inputs, outputs, and supervision features of the POWERPATH NAC Extender Power Supply.
Defines technical terms like CLASS 'A', FACP, EOLR, NAC, SM, DSM, C, NC, NO, and Ahrs used in the manual.
Instructions for inspecting the POWERPATH unit and its packaging for damage upon arrival and checking contents.
Guidelines for mounting the POWERPATH unit in a suitable indoor, dry location, considering temperature and humidity.
Instructions on wiring the POWERPATH, including separation of power-limited and non-power-limited wiring.
Details the location and specific settings for DIP switches on the Control PC Board for various functions.
Guide for calculating standby and alarm current requirements for the PS-8 model to determine battery size.
Guide for calculating standby and alarm current requirements for the PS-6 model to determine battery size.
General| Input Voltage | 100-240VAC |
|---|---|
| Efficiency | >80% |
| Input Frequency | 50/60Hz |
| Output Voltage | +5V, +12V |
| Operating Temperature | 0°C to 40°C |
To Next Page