LAWN MOWER PREPARATION
The following section describes steps necessary to prepare the lawn mower for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800)791-9458 Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the lawn mower or shorten
its lifespan.
UNPACKING
Tools required (not included): #2PH screwdriver, utility knife.
Unpack the lawn mower and all its parts, and compare against the list below. Do not discard the carton or
any packaging until the engine is completely assembled.
1
Side discharge chute
5
Screw M8 (2)
2
Lawn mower with upper handle
6
Flange bolts M6 (4)
3
Lower handle (left and right)
7
Cable clip
4
Knob (2)
8
Spark plug wrench
1 2 3 4 5 6
7 8
To Next Page
Loading...
