powersoft_connecting_dm1000nps_to_500_1000_1000IS_en_v1.0
© 2012 Powersoft
Powersoft S.r.l. • Via Enrico Conti, 5 • 50018 Scandicci (FI) • Italy
+39 055 735 0230 • sales@powersoft.it • www.powersoft-audio.com
How To Connect a DigiMod
1000NPS to a DigiMod
500/1000/1000 IS
1 Introduction
1.1 Preliminary considerations
The DigiMod 1000NPS is an exact replica of the DigiMod 1000 output stage (2-channel bridgeable, 2x500W on 4Ω, 1x1000W on 8Ω),
which can be used in combination with DigiMod 500/1000/1000 IS to extend the range of possible multi-channel congurations and power
3-way active loudspeakers. In order to make this connection possible, the DigiMod 1000NPS must be equipped with an optional DSP-C
board.
Related Products:
▶
DigiMod 1000NPS*
▶
DigiMod 500
▶
DigiMod 1000
▶
DigiMod 1000 IS
* with DSP
1.2 Tools Needed:
▶
1 male MOLEX 3-pin connector
▶
1 female MOLEX 3-pin connector
▶
1 male PHOENIX 5-pin connector (MSTB, 2.5/5-ST-5.08)
▶
Balanced cable (low impedance)
▶
Soldering iron and solder
▶
Powersoft CB000098 cable or equivalent (10 pole 8/10 mm cable, with 2 MOLEX Micro-Fit 3.0 connectors)
▶
pliers for electronic use
2 Procedure
2.1 Connect the Power supply
FIGURE 1: DigiMod 500 power supply connector position
To Next Page
Need help?
General