Need help?Do you have a question about the powersoft DIGAM K series and is the answer not in the manual?
General| Amplifier Class | Class D |
|---|---|
| Number of Channels | 2 |
| THD | <0.5% from 0.1W to full power |
| Input Sensitivity | 1.4 Vrms |
| Damping Factor | >500 |
| Cooling System | Forced air |
| Protection | Thermal, short circuit, DC, overload |
| AC Power | 100-240 V, 50/60 Hz |
| Dimensions | 483 mm (19 in) x 88 mm (3.46 in) |
Introduction to the front panel controls, buttons, and graphic LCD display.
Explanation of the primary display screen status and LED indicators.
How to navigate through the amplifier's main menu options using buttons.
Adjusting the signal level output attenuation for channels in 1dB steps.
Configuring amplifier gain and input sensitivity levels for optimal performance.
Choosing between Analog and Ethernet input sources for the amplifier.
Setting the peak output voltage limit for channels to protect connected equipment.
Adjusting the maximum allowable mains current draw to protect the power source.
Enabling/disabling the clip limiter to prevent output distortion and speaker damage.
Muting channels based on input signal amplitude thresholds to reduce noise.
Displaying historical temperature data and current internal temperature readings.
Monitoring the incoming mains voltage and current of the power supply.
To Next Page