Need help?Do you have a question about the powersoft Quattrocanali 1204 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Power Output (8 Ohm) | 1200 W |
| Power Output (4 Ohm) | 2400 W |
| Amplifier Technology | Class D |
| Output Power Bridged @ 8 Ohms | 4800 W |
| Frequency Response | 20 Hz - 20 kHz (±0.5 dB) |
| Total Harmonic Distortion (THD) | < 0.1% |
| Input Impedance | 20 kΩ |
| THD+N | < 0.1% |
| Signal to Noise Ratio (SNR) | >100dB |
| Damping Factor @ 8Ω | >500 |
| Input Sensitivity | 1.4 V |
| Cooling | Fan cooled |
| Power Supply | Switching power supply |
Recommendations for installing the amplifier in a rack cabinet for optimal performance and safety.
Essential safety warnings and precautions to follow during amplifier installation.
Information on AC power connection, voltage requirements, and recommended circuit breakers.
Procedure for powering the amplifier on, off, and entering standby mode.
Information on network configuration, DHCP, and AutoIP settings for amplifier connectivity.
Overview of signal processing, routing, and DSP features within Armonía for Quattrocanali DSP+D.
Suggested step-by-step configuration workflow using Armonía for optimal setup.
To Next Page
