33
Disconnect the fuel line from the out-
board motor.
Before tilting the outboard motor, stop
the engine by following the procedure
on page 34. Never tilt the outboard mo-
tor while the engine is running. Severe
damage from overheating can result.
Do not tilt up the engine by pushing the
tiller handle (if equipped) because this
could break the handle.
Place the tilt lock lever in the release po-
sition.
Procedure for tilting up (hydro tilt
models)
1Place gear
shift lever in neutral.
4. Move up the lever to sail on shallow wáter
5 Hold the rear of the top cowling with one
hand, tilt the engine up, and turn the tilt
support lever toward you or tilt support
knob into the clamp bracket,
6 then
place the tilt lock lever back into the lock
position to support the outboard motor.
CAUTION
Functioning
To Next Page
Loading...
Need help?
General