PowerTec AF4000 - Mounting the Air Filtration Unit

2
• Ifyounoticeanytransportdamagewhileunpacking,
notify the supplier immediately,
• Disposeofthepackinginanenvironmentallyfriendly
manner.
You should take into consideration how and where you will
place the unit:
• Itcanbeplacedonabenchorbehungfromtheceiling.
• Thisunitwillworkbestifitislocatedawayfromcorners,
and heating/cooling vents.
• Ifusingonsawhorsestheairfiltrationunitshouldbe
clamped in place.
• Thisunitisspecificallydesignedtocirculateandfilter
non-metallic dust, which is generated trhoughout the
work area.
CAUTION: Mounting hooks must be anchored to a building
structure which can support a minimum of 45 kg. Never
mount to surface such as dry wall or false ceiling grids, etc.
Tools required for assembly:
No. 2 Phillips screwdriver (not supplied)
10mm wrench (not supplied)
INSTALLING THE UNIT
Refer to Figure 2 to 4
• Removeallpackingfrominsideoftheunitbyremoving
the outer filter and innner filters.
• Theairfiltrationunitcanbehungfromtheceiling.
Remove four screws from cabinet top (Figure 2).
• Hangtheunitusingfourhookbolts,andfourhexnuts
(Figure 3) provided.
• Thelocknutneedstobethreadedalmostallthewayup
the eye bolt. Screw the eye bolt into the hole and tighten
lock nut against the cabinet top. You will need to hold
the eyebolt so it does not spin while tightening the lock
nut.
• Repeatstepsforremainingthreeeyebolts.
• Drillholesandsecurelymountthefourmountinghooks
provided in the ceiling and use the provided sections of
chain for mounting your air filtration system. (Figure 4)
NOTE: Hang the unit at least 7 Ft. above floor level.
Figure 2
Figure 3
Figure 4
ASSEMBLY
2