EasyManua.ls Logo

POWERTECH PLUS MB-3622 - Completion of Charging; Charging Process Completion; Typical Charging Times

POWERTECH PLUS MB-3622
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
COMPLETION OF CHARGING
When the battery “Full Charge” LED comes on, this mean the
battery is fully charged. The battery charger will now goes into
maintenance mode. No attention is required until the battery is
required for use again.
If the AC plug is pulled off from the mains supply, the battery
charger will turn off. The charging mode and status will be
recorded in the charger’s memory for 15min. Afterward it will reset
to standby mode. This feature will avoid any power failure, and
once power comes back the charger will resume the charging
process at the previous mode.
If the DC clamps were pulled off from the battery while the AC
plug is still connected to the mains supply, the charger will
automatically switch back to the standby mode. Try to avoid
disconnecting the DC clamps while the AC socket is still
intact to power.
CHARGING TIME
The table below is a guide to the typical charge time for varies
size of 12V/6cells battery:
Battery Size Charging Time
20Ah 2 hours
55Ah 4 hours
75Ah 6 hours
96Ah 7 hours
120Ah 9 hours
180Ah 13 hours
225Ah 16 hours
9

Related product manuals