SPECIAL FEATURES
Temperature Control Fan
To protect the charger from overheating, a fan is included for heat
dispensation. Also to increase the life span of the fan, a sensor
will control the on off of the fan, where the fan will not use when
the HFC is not in a hot condition.
Temperature Compensation
A sensor will automatically adjust the charging voltage if the
temperature deviates between – 20°C to +50°C. At a high
temperature environment the unit lowered the output voltage and
at a freezing condition, the unit will adjust a higher output voltage.
Voltage compensation:
Because of some voltage drop in the cables, the actual voltage at
the clamps of the battery can be lower than the charger output
voltage. A special circuitry inside the unit will monitor the true input
voltage to the battery and adjust the output voltage of the unit
accordingly. This will maximize the charging efficiency.
Buzzer Warning
A built in buzzer will help to warn the user when connect the
clamps to the battery wrongly.
Display
Reverse Polarity - Reverse Polarity Connection to Battery
Pole.
Battery Fault – Faulty Battery Indicator.
Charging – While Battery is Charging.
Full Charge – When Battery is Fully Charged and in
Maintenance Mode.
3 X 7 Segment LEDs Display for Charging Current, Battery
Voltage, & Charging %.
Cable Management
The casing is designed with AC and DC cables storage
compartment. This will help to avoid cable damage and
subsequently any possible danger to user.
3
To Next Page
Loading...
