PowerXtreme X30 - Electrical Connections and Prohibitions; Storage, Charging, and Charger Safety

User manual PowerXtreme X20/X30
E18-X20X30-EN00 www.emergoplus.com Page 7 of 25
contact with the electrolyte, rinse it immediately with plenty of water.
After this, consult a doctor.
▪ Use cables of the correct cross-section and keep the cable connections
as short as possible. Use reliable cable clamps and tighten the bolts
firmly.
▪ Never short-circuit the + and - poles. The internal BMS is protected
against short circuits, but to prevent dangerous sparks this is strongly
discouraged.
▪ Never connect the battery pack in series or in parallel with any other type
of battery pack.
▪ Do not use the battery as a starter battery.
▪ Do not open the battery pack. The guarantee is void if the battery is
opened.
▪ Do not place the battery pack in a high temperature environment or in
direct sunlight or near a heat source >45°C.
▪ Never install the battery in rain or damp conditions with RV>80%.
▪ Avoid damage to the battery and/or charger housing.
▪ Do not store the battery in discharged condition (< 11.5V) for a longer
period of time.
▪ If the battery is stored for a longer period of time without use, we
recommend that you charge it once every six months. Don't forget to
disconnect the battery terminals or turn off the ground switch when you
don't use the battery for a longer period of time.
▪ Never charge the battery pack at temperatures below 0 °C.
▪ Always use the supplied charger. This charger is suitable for LiFePO4
cell chemistry with the corresponding charging voltage.
▪ Never use a damaged battery pack.
▪ Make sure that the battery and charger are never covered with clothing
or other materials! This can lead to overheating!
CAREFUL!
Using a charger that is not suitable for LiFePO4
chemicals can damage the battery because it is not
properly charged.