Powrmatic CPx 60 User Manual

Stamm International Corporation
PO Box 1929
Fort Lee, NJ 07024
Tel: 201-947-1700
Fax: 201-947-9662
E-mail: stamminc@pobox.com
Stamm International HQ
www.powrmatic.co.uk
www.powrmatic.co.uk
®
Powrmatic Limited
Hort Bridge, Ilminster
Somerset
TA19 9PS
tel: +44 (0) 1460 53535
fax: +44 (0) 1460 52341
e-mail: info@powrmatic.co.uk
web: www.powrmatic.co.uk
Powrmatic Ireland
45 Broomhill Close
Tallaght
Dublin 24
tel: +353 (0) 1452 1533
fax: +353 (0) 1452 1764
e-mail: info@powrmatic.ie
web: www.powrmatic.ie
Getting In Touch
Powrmatic pursues a policy of continues improvement in both design and performance of its products and therefore reserves the right to change, amend or
vary specifications without notice. Whilst the details contained herein are believed to be correct they do not form the basis of any contract and interested
parties should contact the Company to confirm whether any material alterations have been made since publication of this brochure.
EURO-AIR
QUALITY
ICOM
Energy Association
More information is available from our website by scanning the following QR code.
CPx
User, Installation & Servicing Manual
Issue 2.9 November 2018
Doc Ref: M201 Issue 2.9 Nov 2018
ErP COMPLIANT
SEPTEMBER 2018

Powrmatic CPx 60 Specifications

General

Brand	Powrmatic
Model	CPx 60
Category	Heater
Language	English

Summary

1.2 Technical Data

Technical Specifications and Notes

Detailed technical specs and interpretation notes for CPx models.

Burner Settings and Specifications

Details on gas/oil burner settings, air, pressure, CO2, NOx, temp.

Electrical Loadings and Heater Specs

Standard Motor Drive Data

LHP Motor Drive Data

2.4 Electrical Cable Installation

Electrical Connections & Wiring

Safety, wiring, and controller installation guidance.

2.5 Wiring Diagrams

1-Phase Gas/Oil Wiring Diagram

Wiring diagram for 1-phase gas/oil heaters.

3-Phase Gas/Oil Wiring Diagram (120-200)

Wiring diagram for 3-phase gas/oil heaters (120-200).

3-Phase Gas/Oil Wiring Diagram (250-300)

Wiring diagram for 3-phase gas/oil heaters (250-300).

2.6 Commissioning and Testing

General Installation & Gas Checks

Electrical, gas, oil installation checks and gas controls soundness.

Burner Start-up Sequence

Final Adjustments & Burner Pressure

Steps for final adjustments and Hi/Low burner pressure.

Oil Heater Startup & Warnings

Initial startup for oil heaters and ignition failure warnings.

Oil Burner Final Adjustments

Final adjustment and Hi/Low pump pressure for oil burners.

Heater Handover and Settings

2.7 Servicing

General Servicing Procedures

Gas Burner Replacement & Setup

Instructions for replacing and setting up gas burners.

RSD Gas Burner Setup

Procedure for setting up RSD gas burners.

RGD Oil Burner Setup

Procedure for setting up RGD oil burners.

Fan and Motor Servicing

Fan/Limit Thermostat Replacement

Procedure for replacing the fan/limit thermostat.

3.1 Fault Finding

General Heater Faults

Table of general faults and gas-specific diagnostic codes.

Fault Causes and Solutions

Comprehensive table of faults, causes, and their respective solutions.

Gas Ignition Failure Faults

Specific faults and solutions for gas heater ignition failures.

3.3 Fuel Conversion

Oil Conversion Procedures

Steps for oil conversion, nozzle change, and pressure settings.

Gas/Oil Burner Pressure Data

Tables for gas to propane and propane to gas conversion pressures.

Gas Conversion Procedures

Steps for gas conversion and gas valve pressure adjustments.