To Next PageTo Next Page
Need help?Do you have a question about the Powrmatic LX50 and is the answer not in the manual?
General| Power Output | 50 kW |
|---|---|
| Voltage | 230 V |
| Thermostat | Optional |
| Safety Features | Flame Failure Device, Overheat Thermostat |
| Type | Indirect Fired Oil Heater |
Procedures for fitting the unit and its components.
Preliminary checks to ensure safe operation before lighting.
Steps for safely starting and operating the air heater.
Steps for safely stopping and shutting down the heater.
Guidance on regular servicing for efficient and safe operation.
Components for balanced flue systems (vertical/horizontal).
Guidelines for selecting the optimal installation location.
How to correctly size the heater for the area it is heating.
Requirements for electrical connection and isolation.
Requirements and types of approved flue systems.
Requirements for gas supply, valves, and connections.
Ventilation requirements for different installation types.
Ventilation needs for Type B flued units.
Ventilation needs for Type C flued units.
Requirements for using the unit with ductwork.
Required clearances around the unit for installation.
Minimum distances to obstacles for safe installation.
Safety precautions during installation.
Methods and considerations for suspending the heater.
Considerations for air distribution and ductwork.
Safety regulations and procedures for gas connection.
Requirements for external wiring and connections.
Guidelines for optimal placement of thermostats and controllers.
General rules for installing flue systems and combustion air.
Steps for assembling a vertical balanced flue system.
Steps for assembling a horizontal balanced flue system.
Steps for assembling a vertical single flue system.
Steps for assembling a horizontal single flue system.
Guidelines for making electrical connections.
Internal wiring diagram for specific models.
Internal wiring diagram for specific models.
Checks to ensure electrical safety before commissioning.
Procedures for gas installation inspection and purging.
Preliminary checks before attempting to light the heater.
Steps for operating the heater during commissioning.
Procedures for adjusting burner gas pressures and regulation.
General guidance and safety for performing servicing.
Steps for removing the main burner assembly.
Checks and maintenance of the heat exchanger integrity.
Guidance on using genuine parts for replacements.
Procedures for replacing the R2R main control board.
Interpretation of LED fault codes and states.
Interpretation of R2R main board status indicators.
Final steps in the fault finding diagnostic flow chart.
