1. INTRODUCTION
The Powrmatic TE range of gas fired forced draught, closed
flue, fanned circulation air heaters cover a heat output range
of 220 kW (75000 Btu/h) to 806 kW (2750000 Btu/h) and are
intended primarily for heating commercial or industry
premises. They are certified for use on Natural Gas, Group
H - G20.
The heaters are for floor mounting, freeblowing applications
only.
TE heaters have a double axial fan assembly fitted
upstream of the combustion chamber / heat exchanger
assembly to circulate the air being heated.
Heaters are fitted as standard with fully automatic monoblock
forced draught gas burners and monoblock gas control
assemblies and are available with either High/Low or
modulating burners.
Each air heater must be connected to a closed flue system
only.
Gas Safety (Installation & Use) Regulations 1994
It is law that all gas appliances are installed, adjusted and,
if necessary, converted by qualified persons* in accord-
ance with the above regulations. Failure to install appli-
ances correctly can lead to prosecution. It is in your own
interests and that of safety to ensure that the law is
complied with.
To Next Page
