PPA Agility Hibrida - Automatic Modes and Ramps; Automatic Closing Mode (Pause Time); Opening Ramp Adjustment

28
- After properly in󰍰alling the gate opener, adju󰍰 the electronic clutch so that the
󰍰rength necessary to a complete gate maneuver is minimum when the device is both
opening and closing.
In󰍰ructions:
1. The gate mu󰍰 be 󰍰ill;
2. Close the ‘JPROG’ jumper;
3. Press and release the ‘FORCE’ button on the board (once) to show the current
adju󰍰ment;
4. Press and release the ‘FORCE’ button as many times as necessary until one rea-
ches the desired adju󰍰ment;
5. In order to finish, open the ‘JPROG’ jumper.
LED indications:
• ‘N1’ flashing = Off.
• ‘N1’ lit = Minimum.
...
• ‘N8’ lit = Maximum.
SEMI-AUTOMATIC / AUTOMATIC MODE (PAUSE TIME)
It is the time adju󰍰ment for the automatic closing when the gate reaches the opening
limit switch (LSO) or the opening 󰍰op, indicating the limit of the opening maneuver.
In󰍰ructions:
1. The gate mu󰍰 be 󰍰ill;
2. Close the ‘JPROG’ jumper;
3. Press and release the ‘PAUSE TIME’ button on the board (once) to show the cur-
rent adju󰍰ment;
4. Press and release the ‘PAUSE TIME’ button as many times as necessary until one
reaches the desired adju󰍰ment;
5. In order to finish, open the ‘JPROG’ jumper.
LED indications:
• ‘N1 flashing = Semi-automatic.
• ‘N1 lit = 5 seconds.
• ‘N2’ lit = 10 seconds.
• ‘N3’ lit = 30 seconds.
• ‘N4’ lit = 60 seconds.
• ‘N5’ lit = 90 seconds.
• ‘N6’ lit = 120 seconds.
• ‘N7’ lit = 180 seconds.
• ‘N8’ lit = 240 seconds.
OPENING RAMP
It is the di󰍰ance between the opening mechanical 󰍰op and the point of the path
where the electronic board enters torque control mode in order to decrease the speed
of the gate and turn the opener off on the acquired path, i.e., the di󰍰ance in which the
opener 󰍰arts decelerating when opening the gate.
In󰍰ructions:
1. The gate mu󰍰 be 󰍰ill;
2. Close the ‘JPROG’ jumper;
3. Press and release the ‘OPEN RAMP’ button on the board (once) to show the
current adju󰍰ment;
4. Press and release the ‘OPEN RAMP’ button as many times as necessary until one
reaches the desired adju󰍰ment;
5. In order to finish, open the ‘JPROG’ jumper.