PPA Agility Hibrida - Photocell Settings; Photocell Output Contact Type; Photocell Analog Output (Edge Sensor)

42
Opening / Closing photocells setting screens
Setting the Photocell output’s NO (Normally Open) contact
Selects the Contact type
Setting the photocell analog output (Edge sensor)
Current analog value
measured on the
microcontroller pin.
Selects
the type of
contact
Stores the analog value when
the edge sensor is on stand-by.
Stored analog value when the
edge sensor is on stand-by. When
installing the edge sensor, it
must perform the procedures for
memorizing this value to serve as a
resting reference.