PPS RPS 110CC - Engine Starting and Stopping; Starting a Cold Engine; Stopping the Engine

11
ENGINE STARTING
CAUTION
Verify oil level prior to starting.
Starting the engine with low or no oil will damage the engine.
WARING
Never start the engine in a closed place as the exhausted gas from the vehicle contains
toxic carbon monoxide.
1. Set the key of the ignition switch to position.
2. Put the dirt bike in the neutral gear.
3. Ensure that there is fuel in the tank.
4. Set the fuel valve handle to “ON” or “RES” position.
To start a cold engine:
1. Pull up the choke lever of the carburetor (to close the choke).
2. Start the engine with kick lever.
3. Slightly turn the throttle twist grip to increase the speed of the engine so as to warm up
the engine.
4. Turn the carburetor choke bar downward to fully open the choke when the engine is
sufficiently warmed up.
CAUTION
Unnecessarily increasing RPM’s to a high level while the dirt bike is in neutral is harmful to
the engine.
Procedures for stopping the engine:
1. Release the throttle twist grip to slow down the engine.
2. Shift to the neutral position.
3. Set the ignition switch key to “ ” position.
4. Set the fuel valve handle to “OFF” position.