19
ADJUSTMENT OF CHAIN
1. When chain adjustment is needed, loosen rear axle nut .
2. Turn the chain adjusting brackets on the left and right sides to adjust the tension of the
chain and to align the marking of the chain adjuster with the engraved lines in the similar
position on both sides.
3. Tighten rear axle nut by a torque of 50-60Nm (37-44 ft.lb.).
4. Repetitively check the tension of the chain.
GREASING PROCEDURES TO THE DRIVING CHAIN
1. Shut off the engine
2. Add light amounts of machine oil or chain grease to the driving chain.
(Too much machine oil or chain grease may cause splattering to occur.)
Attention:
The chain should be replaced when the adjusting limit has reached it’s maximum.
TROUBLESHOOTING
This troubleshooting guide is provided to help you to find the cause of some common
complaints.
COMPLAINT: Engine is hard to start or does not start at all. Something is probably wrong
with the fuel system or ignition system.
CAUTION
Failing to troubleshoot a problem correctly would damage your Dirt Bike.
Improper repairs or adjustments may damage the vehicle. Such damage may not be
covered under warranty. If you are not sure about the proper action, consult your
authorized service center or Ricky Power Sports LLC. about the problem.
To Next Page
Loading...