14
4. Do not use the front brake only or coast using the neutral gear especially when
descending or driving at a high speed.
5. Decrease the throttle when braking.
CHECK-UPS, ADJUSTMENT AND MAINTENANCE
Checking the Oil
Check the engine oil each time prior to operating the dirt bike.
The oil level should be between the upper and lower lines of the oil sight gauge located on
the right cover of the crankcase. The level can also be checked on the dip stick.
1. Set the motorcycle on level ground, look at the sight gauge for current oil level. Remove
the oil gage plug, wipe the oil gage rod clean and then insert the gage plug into the
crankcase again to check the oil level. There is no need to completely install the oil gage
plug in the crankcase fill hole.
2. Add lubricating oil up to the upper line when needed, but do not overfill.
3. Finally screw on the oil gage plug tightly.
CAUTION
Never start the engine when there is in sufficient
lubricating oil. Otherwise, it will cause harm to the
engine.
LUBRICATING OIL RECOMMENDED
The lubricating oil is an important factor
affecting the performance and service
life of the engine. Please refer to the
chart for the correct grade of engine oil
based on the environmental conditions
in your area. Do not use any other type
of oil other than what is recommended
in the chart. DO NOT MIX OIL WITH
THE GASOLINE.
Lubricating oils of different viscosity
shall be employed in different regions
and at different temperatures.
To Next Page
Loading...
Need help?
General
