3
SAFE OPERATION
A pre-operation check must be conducted before starting the engine.
This check will insure safety, prevent mishaps, and prevent damage to components.
It is strongly suggested that all operators take a certified motorcycle rider’s course prior to
operating the vehicle.
Full attention is required during driving; paying close attention to the following points to avoid
any injury to you by other motorized vehicles:
Do not drive too close to other vehicles.
Never carry a passenger. This dirt bike is for one operator only.
Never operate this dirt bike at night. Night is defined as the period of time 30 minutes
before sunset to 30 minutes after sunrise.
Driving at high speeds is the cause of many accidents; do not drive at a speed that the
actual situation does not permit.
Always avoid operating this dirt bike on paved surfaces, including; sidewalks, paths,
parking lots, driveways, streets, roads, and highways.
Never operated this or any Off-Road Vehicle on a public street, road or highway where motor
vehicles are in operation.
PRE-RIDE CHECKLIST
1. Engine oil level
a) Check for leaks
b) Tighten filler cap securely.
c) Add oil if required.
2. Fuel level
a) Add fuel as necessary.
b) Do not overfill (no fuel in the filler neck).
c) Do not mix oil with gas.
d) Replace cap tightly.
e) Do not refuel a hot engine. Allow engine to cool before adding fuel.
3. Warning decals
a) Make sure all warning decals are legible and securely attached.
b) Replace as necessary.
4. Tires
a) Ensure that both tires are in safe riding condition.
To Next Page
Loading...
Need help?
General
