17
ADJUSTING THE CARBURETOR
When the vehicle leaves the factory, the idle speed has been
optimized and the user does not need to adjust it. If the idle speed
is indeed unstable, please go to the local dealer for treatment.
CAUTION
The vehicles have no adjustable operating parameter. Idle
screw is within 1500±100 rpm, so the range is within 100
rpm of default idle speed. The idle screw is covered by a
chock plug to prevent tampering by the consumer. OEM
guarantees all production vehicles will be installed with
prevent tampering device on idle screw to ensure idle screw
non-adjustable.
INSPECTION OF FRONT HYDRAULIC DISK BRAKE
1. Inspect the front disk brake caliper for leakage. If brake fluid leaks, the safety of riding
could be affected.
2. Inspect the brake hose for cracks, and the joint for leakage.
3. Check the brake fluid level in the brake fluid reservoir, if level is at or below the LOWER
mark, inspect brake pads for wear and hydraulic system for leaks.
4. To add brake fluid, unscrew the 2 screws on top of the bake fluid container. Add DOT3 or
DOT4 brake fluid. Do not mix brake fluid types.
FRONT HYDRAULIC DISK BRAKE INSPECTION REAR HYDRAULIC DISK BRAKE
INSPECTION
1. Inspect the rear disk brake caliper for leakage. If brake fluid leaks, the safety of riding
could be affected.
2. Inspect the brake hose for cracks, and the joint for leakage.
3. Check the brake fluid level in the brake fluid reservoir, if level is at or below the LOWER
mark, inspect brake pads for wear and hydraulic system for leaks.
To Next Page
Loading...
