MW
3
1. INTRODUCTION
This manual describes the instructions for repair of the MW pump family and should be carefully read and
understood before any intervention on the pump.
Proper pump operation and duration depend on the correct use and maintenance.
Interpump Group disclaims any responsibility for damage caused by negligence or failure to observe
with the standards described in this manual.
2. REPAIR GUIDELINES
2.1 Repairing mechanical parts
Mechanical parts repair must be performed after removal of oil from the casing.
To take out the oil, remove the oil dipstick pos.c, fig. 1 and then the discharge plug pos.d, fig.1
The oil must be placed in a suitable container and disposed of in special centres.
It absolutely should not be discarded into the environment.
fig. 1
To Next Page
Loading...
