STEP 1:
STEP 2:
CHARGE YOUR CAREF BEFORE USE
WATERPROOF/WATER RESISTANT
MOTION SENSOR
TURN ON YOUR CAREF WATCH
The Caref package contains a colorful USB
cable and charger. Before using Caref, please
charge it for at least one hour. The cable is
inserted in the port as seen here: Caref will last
24-48 hours based on calls placed/received.
Treat it like a cell phone, which is typically
charged at the end of a day.
Caref is designed to be waterproof but it’s VERY IMPORTANT that you fully
close the Cover to the USB port. If this is not done, the Caref will NOT be
waterproof; it will only be water resistant. It is recommended that Caref not be
worn in the pool or ocean.
Caref has a motion sensor that activates the GPS chip inside the watch. When
the watch is not moving, it will NOT transmit location. When worn, the motion
sensor activates the watch and tells it to “get to work.”
Hold down on the Power Button for three
seconds to turn on your Caref On or Off .
VERY IMPORTANT: It is recommended that
you take your watch outside for 5 minutes so
it can get a good GPS “ x” the rst time you
use it. A best “ x” occurs when you have an
unobstructed view of the sky.
To Next Page
Loading...