REMOTE CONTROL INSTALLATION
REMOTE SUBWOOFER LEVEL CONTROL
This input allows you to add a remote that will enable you to control your ATOM amplifier's subwoofer
output from your dashboard. There is a level control provided on the amplifier next to the phone jacks to
adapt the amplifier to all kinds of signal sources with varying levels. It should not be used as volume
controls. Start with a "12' clock" setting of the level controls. If you set the head unit volume to 75% of the
maximum, you should achieve good sound without distortion. Find a point of the level setting where the
distortion is just discernible. At this point, slightly reduce the control.
HOW TO INSTALLATION
The dash control mounts with two screws, which attach to the underside of the dashboard. Slide under
the dash and place the dash control in its mounting position, mark the two mounting holes, drill pilot
holes, and secure with two screws.
11
To Next Page
Loading...
