Need help?Do you have a question about the Precision Power PCX 1250 and is the answer not in the manual?
General| RMS Power at 2 Ohms | 600W x 1 |
|---|---|
| RMS Power at 1 Ohm | 1250W x 1 |
| Signal to Noise Ratio | >100 dB |
| Damping Factor | >200 |
| Input Sensitivity | 0.2V - 6V |
| Bass Boost | 0 - 18 dB |
| Phase Shift | 0° - 180° |
| Efficiency | 85% |
Guides user through checking power and ground for no sound.
Advises contacting dealer or support for persistent no sound issues.
Provides steps to diagnose and fix sound issues in a single channel.
Lists the primary features and new technologies of the amplifiers.
Details technical specifications like bandwidth, distortion, and sensitivity.
Provides power output ratings and physical dimensions for the models.
Illustrates the internal signal flow and components of the PCX1250.
Illustrates the internal signal flow and components of the PCX1500.
Explains the QBASS bass boost feature and its graphical representation.
Provides a detailed chart of crossover frequency settings based on detent numbers.
Details fuse ratings and installation requirements for safety.
Explains heatsink design and forced air cooling for amplifier temperature control.
Provides general wiring safety precautions and recommended routing paths.
Details the process of connecting speaker wires using PowerLock connectors.
Explains how to connect power and ground wires using PowerLock connectors.
Explains the functions of controls and connectors on the PCX 1250 endplate.
Explains the functions of controls and connectors on the PCX 1500 endplate.
Provides detailed instructions for proper ground wire connection and placement.
Explains input jacks, attenuation, and advanced instrumentation for noise reduction.
Discusses potential charging system upgrades for high-power audio systems.
Provides formulas and tables to calculate current draw for wire gauge selection.
Explains the TC-X crossover system and its HP/LP/Full settings.
Details the specific crossover settings available for PCX 1250 and PCX 1500.
Shows settings for QBASS™™ on PCX 1500, including frequency and level.
Explains AP-IV and AM-V protection circuits for short circuits and thermal issues.
Lists the primary features of the PCX 1500 amplifier.
Details technical specifications, power ratings, and dimensions for the PCX 1500.
Shows system design examples using PCX amplifiers for various audio configurations.
Advises on service procedures, safety cautions, and hearing protection.
Details warranty terms for authorized and non-authorized installations.
Outlines general conditions, exclusions, and limitations of the warranty.
To Next Page
