Need help?Do you have a question about the Precision Power D1000/1 and is the answer not in the manual?
Lists all items included with the amplifier package.
Technical specifications for amplifier models adhering to CEA standards.
Power output details for each amplifier model at different impedances.
Covers conversion efficiency, frequency response, THD, and input sensitivity.
Recommended fuse ratings and installation guidelines for amplifier power wires.
Physical dimensions for each amplifier model.
Explanation of Power, Short, and Thermal status LEDs on the amplifier.
Lists necessary tools for amplifier installation, noting they are not supplied.
Detailed instructions for proper grounding of the amplifier for optimal performance.
Advice on upgrading vehicle charging systems for high-power amplifiers.
Recommendations for power and ground wire gauge based on current draw.
Step-by-step guide for connecting power and ground cables using PowerLock connectors.
Identification and function of controls on the amplifier's front panel.
Details on power/ground connectors, QBASS REMOTE, and QBASS Level Control.
Explanation of the noise-reducing input stage for improved audio signal integrity.
Details on the bass boost feature with selectable frequencies and Q-factor.
Explains QBASS PLUS settings and the optional remote dash control.
Describes the built-in TC-X crossover for speaker and RCA outputs.
Table detailing low and high pass crossover frequencies based on detent settings.
Information on the amplifier's internal heatsink for thermal management.
Details on AP-IV Short Circuit and Thermal Protection features.
Initial steps for diagnosing and resolving common amplifier issues.
Outlines the terms, conditions, and limitations of the product warranty.
General| Number of Channels | 1 |
|---|---|
| S/N Ratio | >90dB |
| Damping Factor | >200 |
| Bass Boost | 0dB - 12dB |
| Fuse Rating | 40A |
| Power Output (1 Ohm) | 1000W |
| Crossover | Low Pass |
| Input Sensitivity | 0.2V - 6V |
To Next Page