917, 917si Treadmillr
Page 6
Procedure 2.2 - Displaying the Odometer
(917si only)
The keys on the display are hypothetically numbered for 1 to 7 from left to right. Therefore,
INCLINE
▲ would be key 1, INCLINE ▼ would be key 2, etc.
This procedure allows you to display the number of miles or kilometers logged on the treadmill.
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker
2. Press keys RESET,6,5, sequentially.
3. The console displays the number of miles or kilometers logged on the treadmill. Press the
STOP key to continue.
4. The total number of hours the treadmill drive motor has been operating will be displayed.
Press the STOP key to continue.
5. The software version will be displayed. Press the STOP key to continue.
6. The error code log will be displayed. There may be up to ten error codes logged. The error
code and the odometer reading when the error occurred will be displayed. Use either
▲ to
move forward through the error code log position. Use either
▼ to backward through the
error code log.
7. If you no longer require the contents of the error code log for troubleshooting and wish to
clear the error code log, press the STOP and QUICK START keys, simultaneously.
8. Press the STOP to exit.
To Next Page
Loading...
Need help?
General
