9.33, 9.35 240V Treadmill
Page 9
Procedure 2.3 - Setting Club Parameters
This procedure allows you to change the following settings:
• Safety Code
• Select Units
• Set Max Pause Time
• Set Cool Down Time
• Set Speed Limit
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. Refer to diagram 2.1 above and press keys RESET,5,6,7,1 sequentially. Use the numeric
keypad to enter the number sequence. The ARROW keys will step you through the display
modes listed above, allowing you to skip displays or view only specific displays.
3. The display will momentarily display DIAGS - SET PARAMETERS
4. SAFETY CODE
5. Press the OK or ENTER key. When enabled the safety code will require the user to enter a
“password” before the trammel can be used.
6. Use the ARROW keys to select either ENABLED or DISABLED.
7. Press the OK or ENTER key to exit the safety code display
8. SELECT UNITS
9. The currently selected measurement unit will then be displayed.
10. Use the ARROW keys to toggle between U.S. and METRIC.
11. Press the ENTER key to select the currently displayed measurement unit.
12. SET MAX PAUSE TIME
13. Press the OK or ENTER key.
14. Use the ARROW keys to set the maximum pause time between 1 and 10 minutes.
15. Press the ENTER key to select the currently displayed pause time.
16. SET COOL DOWN TIME
To Next Page
Loading...
