20 Operating and Maintaining the P30 Console
Note: On self-powered equipment, the battery initializes
when you begin working out. You must maintain a minimum
rate of motion for the Welcome banner to appear.
The changes made in System Setting modes become the
default settings when the display resets to the Welcome
banner.
CAUTION: If you change the Unit of Measure display on the
treadmill, check the speed setting to verify that it is correct.
To view the Club Parameters settings:
1. At the Welcome banner, press Pause.
2. Press the following number keys in sequence to enter the
password:
5 6 5 1 5 6 5
3. Press OK.
The Set Club Parameters banner appears.
Table 2. Navigational keys for the system setting modes
Key Function
▲ or ▼ Guides you through the settings menu and selections.
OK Select a menu selection.
BACK Returns to the previous menu level without saving
changes.
PAUSE Exits the System Settings mode and returns to the
Welcome banner.
To Next Page
Loading...
