Chapter 3
Setting Up the Console
Use the System Settings mode to configure settings in a way
that benefits your users and your facility. The System Settings
menu is visible only to administrators and registered service
technicians. Changes made to these settings are saved to the
fitness equipment.
The System Settings categories are:
Club Settings
Informational Display
System Settings
System Setting features remain hidden from club patrons and
can only be accessed using special keypresses. To view the
System Settings, the equipment must be in the Welcome
state and display the Welcome banner. To access the
Welcome banner, you must power the equipment. For
self-powered equipment, use the optional power adapter,
otherwise you will have to maintain the minimum rate of
motion. For more information on self-powered equipment,
refer to Activating the Console for Self-Powered Equipment.
The equipment is in the Welcome state when it is on, but not
actually in use. This means that there is no exercise session,
data entry, or diagnostic operation in progress.
When the equipment is in the Welcome state:
PRECOR scrolls on the lower text display. SELECT A
WORKOUT OR PRESS QUICKSTART TO BEGIN scrolls
in the upper text display.
The heart rate signal is the only segment activated.
On the treadmill, the belt is not moving and the lift motor
is off.
To Next Page
Loading...
Need help?
General
