C954, C956 Treadmill
Page 1-42 Page 42
13. Slide the allen wrench into the left hand (upper) lift pin alignment hole and tap the lift pin into
its frame bushing as described in step 12.
14. Slide the retaining bolt into its mounting hole and apply slight inward pressure on the
retaining bolt. Rotate the lift pin using the allen wrench until you feel the retaining bolt “drop”
into its chamfered and threaded hole in the lift pin. Hand thread the retaining bolt into the lift
pin as far as possible. Care must be taken to ensure that you do not cross thread the
retaining bolt.
15. Hand thread the right hand (lower) retaining bolt into the lift platform as described in step 14.
16. Tighten both lift platform retaining bolts.
17. Fasten the lift motor tube to the lift platform with the clevis pin and hitch pin removed in step
3.
18. Check treadmill operation per Procedure 3.
To Next Page
Loading...
