C956i, C966i (Gen 06) Treadmill
Page 1-24 Page 24
Procedure 5.3 - Troubleshooting Hand Held Heart Rate
Circuit Description
The hand held heart rate system is actually a dual system, that is, it can accept a heart rate
signal from either the hand held heart rate contacts on the handlebar or from a Polar heart rate
chest strap transmitter. The system is set for hand held heart rate priority, that is if both a chest
strap and hand heart rate signal is being received, the system will accept the hand held signal
and ignore the chest strap signal.
Diagram 5.5 - Hand held/chest strap heart rate PCA
Normal hand held reading - No chest strap reading
1. Set the on/off switch in the “on” position and access the diagnostic program (Procedure 2.1).
Advance to the heart rate display portion of the diagnostic program. Verify that a chest strap
signal is not being accepted with either a Polar heart rate test transmitter or a known good
chest strap transmitter. If this reading is good, skip to step 3.
2. Using a Polar heart rate test receiver, verify the operation of the chest strap transmitter. If
the Polar heart rate test receiver does not receive a signal, replace the chest strap
transmitter.
3. Set the on/off switch in the “off” position and remove the display housing.
4. Verify that a ferrite bead is installed on the heart rate PCA to upper PCA cable.
5. If the above procedures did not correct the problem, replace the heart rate PCA.
To Next Page
Loading...
